Pellerin Milnor Corporation

Technical Knowledge Base

Dip Switches

There are 3 dip switches on most inverter models. It is important that these dip switches be set properly.
Before you power up the inverter, set the dip switches.

S1 is set to V & it is to the right of the board.
S2 is set to ON & it is to the left of the board.
S3 is set to SINK & it is to the bottom/center of the board.
Last updated: 11/12/2013 / Node ID: 1977 / Key Chain: 12.1.74.7B9.