Miltrol Controls
Information on Miltrol Controls
This section contains information regarding Miltrol Controls
I. Mark I
A. Open Frame Relays
B. 11, 13 or 17 Chart Fingers
II. Mark II
A. 11-pin plug-in (ice cube) relays
B. 24 Chart fingers
C. Tilting machines might have three heads:
1. Wetmil for wash formula
2. Sitmil for chemical injetion
3. Tiltmil for tilting function
III. Mark III
A. 34 chart fingers
B. Three heads
1. Wetmil
2. Sitmil
3. Tiltmil
C. TotalTrol receiver handles datapass functions
IV. Mark IV
A. 34 chart fingers
B. Four heads
1. Wetmil
2. Sitmil
3. Tiltmil
4. TotalTrol receiver
V. Mark V
A. 14-pin plug-in (ice cube) relays with wire-wrapped sockets.
This information is extracted from Milnor manual MXUUUU01- Guide to basic troubleshooting. WLS 4/22/02